Configure network services settings (2024)

To configure network settings, choose one of the following options:

From Remote Manager

1. Click the Device Management tab.
2. From the device list, double-click the device to display the device properties menu.
3. Click NetworkServices.
4. Complete the fields and click Save to save your changes.

From the XBee Gateway web interface

1. Access and log into the web interface.
2. Click Configuration >Network Services. The NetworkService Configuration page appears.
3. Choose one of the following options:
   • To enable a network service, select the check box next to the service and type a port number in the TCPPort field.
   • To disable a network service, clear the check box next to the service.
4. Select the one of the following modes from the Device Discovery Services ADDPMode drop-down list:
   • Read-Write: Allows discovery of devices and the ability to change network settings through the Digi Device Discovery utility. This is the default setting on firmware versions 3.2.29.x and earlier.
   • Read-Only: Allows discovery of devices only. This is the default setting on firmware versions 3.2.30.x and later.
   • Off: Turns off the ADDP network service. This setting completely closes the network port used for device discovery.
5. Click Apply to save your changes.