🕑 Reading time: 1 minute
A Dummy activity is a type of operation in a project network which neither requires any time nor any resource. It is an imaginary activity shown in a project network to identify the dependence among operation.
The representation and more features of dummy activity in network analysis are explained below.
Features of Dummy Activity
Dummy activity forms a connecting link for control purpose or for maintaining the uniqueness of the activity. A dummy activity is used to maintain the network logic and to avoid ambiguity.
An activity followed by a dummy activity can only be completed once the activity or activities preceding the dummy activity is completed.
A dummy activity can be either critical or non-critical. It becomes a critical activity when the earlier start time and the latest finish time are equal.
Representation of Dummy Activity
A dummy activity, being an imaginary or redundant activity, is represented by a dotted line with an arrowhead. The numbers on the terminal nodes are used to represent a dummy activity. A dummy activity is clearly explained by an example in figure-1.
Consider 2 sets of activities as Set 1 and Set 2.
Set 1
A: Delivery of New Machines
B: Install New Machines
Set 2
C: Remove Existing Machine
D: Dispose Existing Machine
As shown in the network above, A and B can be performed serially. The activities C and D can also be performed serially. But practically, the activity D of set 2 can only be performed after completing the activity B of set 1.
So a dummy line is drawn between node 2 and node 5 indicating that the activity D can only be performed after the event 2 is over.
Uses of Dummy Activity
The dummy activity serves the following purposes in a project network:
- Grammatical Purpose
- Logical Purpose
1.Grammatical Purpose
A dummy activity can be used to prevent two arrows with a common beginning and end points. This can be explained by an example as shown in the figure-2.
Consider the arrows of activities A and B. Both start from node 1 and end at node 2. This arrangement is difficult to conduct computations and the network loses its uniqueness in its identification. Such inconvenience causes frequent mistakes during network analysis.
2. Logical Purpose
It is difficult to represent an activity having two sets of operation running parallel to each other in a network. The use of a dummy activity helps to give a logical representation without difficulty in interpretation.
For example, consider the network given in figure-3 where there are two activities Q and R. Both have a common end node. The predecessors of Q are O and P while that of R are P and N.
Rules for Using Dummy Activity in Network Analysis
Too much use of dummy activities in a network creates confusion. Initially, liberal use of dummy activities is followed to
